Multi-Tech Systems MVPFX2-2 - Manual (Page 84)

Technical Configuration MultiVOIP FX User Guide
84
FXO Interface: Parameter Definitions*
FXO Options
Ring Count 1-99 Number of rings required
before the MultiVOIP answers
the incoming call.
No Response
Timer 1 – 65535
(in seconds) Length of time before call
connection attempt is
abandoned.
Flash
Generation 50 - 1500
milliseconds Length of flash hook that will
be generated and sent out when
the remote end initiates a flash
hook and it is regenerated
locally. Default = 600 ms.
Disconnect Options
Current Loss Y/N Disconnection to be triggered
by loss of current. That is,
when Current Loss is enabled
(“Y”), the MultiVOIP will hang
up the call at a specified
interval after it detects a loss of
current initiated by the attached
device.
Current Loss
Timer 200 to 2000
(in milliseconds) Determines the interval after
detection of current loss at
which the call will be
disconnected.
DTMF Tone Y/N Enables supervision of call
disconnection using DTMF
tones.
Low Tones
697Hz
770Hz
852Hz
941Hz
High Tones 1209Hz 1336Hz 1447Hz 1633Hz
DTMF Tone Pairs
1
4
7
*
2
5
8
0
3
6
9
#
A
B
C
D