Multi-Tech Systems MVPFX2-2 - Manual (Page 54)

Mechanical Installation & Cabling MultiVOIP FX User Guide
54
4. For an FXS connection: Examples - analog phone, fax machine,
Key Telephone System
Connect one end of an RJ-11 phone cord to the Channel 1 FXS connector on the
back of the MultiVOIP. Connect the other end to the device or phone jack.
For an or FXO connection: Examples - PBX extension, POTS line from telco central office
Connect one end of an RJ-11 phone cord to the Channel 1 FXO connector on
the back of the MultiVOIP. Connect the other end to the device or phone
jack.
5. Repeat the above step to connect the remaining telephone equipment to the second channel on your
MultiVOIP.
6. Ensure that the unit is properly connected to earth ground by verifying that it is reliably grounded when
mounted within a rack.
This can be accomplished by connecting a grounding wire between the chassis and a metallic object that
will provide an electrical ground.
7. Turn on power to the MultiVOIP by placing the ON/OFF switch on the back panel to the ON position.
Wait for the BOOT LED on the MultiVOIP to go off before proceeding. This may take a few minutes.
Proceed to the MultiVOIP & Auxiliary Software chapter for considerations about the Java and browser
requirements in relation to the MultiVOIP web GUI.