Maxtor ATLAS 10K III - Manual (Page 12)

Table of Contents
xi Maxtor Atlas 10K III
.KUV QH 6CDNGU
Table 3-1 SCSI ID Selection on Option Connector (68-Pin SCSI Connector Drives) . 3-8
Table 3-2 SCSI ID Pin Assignments (SCA-2 Connector Versions of the Disk Drive) . 3-12
Table 3-3 Spin Up on Power On Options ................................................................. 3-13
Table 3-4 68-Pin Wide LVD Pin Assignments ........................................................... 3-16
Table 3-5 80-Pin SCA-2 LVD Pin Assignments......................................................... 3-17
Table 3-6 68-Pin Wide Single-Ended Pin Assignments .............................................. 3-19
Table 3-7 80-Pin SCA-2 Single-Ended Pin Assignments............................................ 3-20
Table 3-8 Power Connector (J1, Section A)............................................................... 3-21
Table 3-9 J1 Auxiliary 12-Pin Connector .................................................................. 3-22
Table 4-1 Specifications ............................................................................................... 4-1
Table 4-2 Formatted Capacity...................................................................................... 4-3
Table 4-3 Timing Specifications for Maxtor Atlas 10K III ............................................ 4-4
Table 4-4 Power Reset Limits1 ................................................................................... 4-5
Table 4-5 Power Dissipation in Various Modes (Low-Profile Drives)........................... 4-6
Table 4-6 Acoustical Characteristics—Sound Power per ISO 7779 .............................. 4-7
Table 4-7 Environmental Specifications ....................................................................... 4-8
Table 4-8 Shock and Vibration Specifications ............................................................ 4-10
Table 4-9 Error Rates ................................................................................................ 4-11
Table 5-1 Supported SCSI Commands ........................................................................ 5-1
Table 5-2 Typical (6-Byte) Command Descriptor Block-Data Format ......................... 5-3
Table 5-3 Command Descriptor Block-Field Descriptions ........................................... 5-3
Table 5-4 Typical (6-Byte) Command Descriptor Block — Data Format..................... 5-4
Table 5-5 Command Descriptor Block Control Field-Field Descriptions ..................... 5-5
Table 5-6 Status Codes ................................................................................................ 5-6
Table 5-7 Length Fields ............................................................................................. 5-10
Table 5-8 DATA-Phase Command Contents............................................................. 5-10
Table 5-9 CHANGE DEFINITION Command Descriptor Block-Data Format........ 5-13
Table 5-10 CHANGE DEFINITION-Field Descriptions............................................ 5-13
Table 5-11 FORMAT UNIT Command Descriptor Block-Data Format .................... 5-15
Table 5-12 FORMAT UNIT Command-Field Descriptions ....................................... 5-15
Table 5-13 FORMAT UNIT Command Supported Options ...................................... 5-16
Table 5-14 FORMAT UNIT Parameter List-Data Format .......................................... 5-16
Table 5-15 .FORMAT UNIT Defect List Header-Data Format .................................. 5-17
Table 5-16 FORMAT UNIT Defect List Header-Field Descriptions........................... 5-17
Table 5-17 FORMAT UNIT Defect Descriptor-Block Format................................... 5-18
Table 5-18 FORMAT UNIT Defect Descriptor- Physical Sector and Bytes
From Index Format ................................................................................... 5-18
Table 5-19 FORMAT UNIT Initialization Pattern Descriptor-Data Format................ 5-19