Grizzly G1033X - Manual (Page 22)

-20-
Model g1033X (Mfg. since 4/12)
Tighten v-belts
the final step in the set up process must be done
after approximately 16 hours of operation. during
this first 16 hours, the v-belts will stretch and seat
into the pulley grooves. After this 16 hours, the
v-belts must be tensioned or your belts will slip
and burn out. refer to
Page 27 when you are
ready to perform this important adjustment.
Note: Pulleys and belts run very hot. This is a
normal condition. Allow them to cool before mak-
ing adjustments.
Note: A collection of black belt dust at the bottom
of the belt housing is a normal during the life of
the machine.
For your convenience, the adjustments listed
below have been performed at the factory and
no further setup is required to operate your
machine.
however, because of the many variables involved
with shipping, some of these adjustments may
need to be repeated to ensure optimum cutting
results. Keep this in mind as you start to use your
new planer.
Step-by-step instructions for these adjust-
ments can be found in SECTION 7: SERvICE
ADJUSTMENTS.
1. table parallelism (Page 32).
2. Chain drive tension (Page 32).
3. infeed/outfeed roller height (Page 34).
4. spring tension (Page 37).
5. Chip Breaker height (Page 34).
6. pressure Bar height (Page 34).
7. Chip deflector positioning (Page 37).
Recommended
Adjustments