Grizzly G1033X - Manual (Page 21)

Model g1033X (Mfg. since 4/12)
-19-
before starting the planer, make sure you
have performed the preceding assembly
and adjustment instructions, and you have
read through the rest of the manual and
are familiar with the various functions and
safety features on this machine. failure to
follow this warning could result in serious
personal injury or even death!
Test Run
once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation. the test run consists
of verifying the following: 1) the motor powers up
and runs correctly and 2) the stop button safety
feature works correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 29.
if you cannot find a remedy, contact our tech
support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure you understand the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2. Make sure all tools and objects used during
set up are cleared away from the machine.
3. Make sure the gearbox has the correct
amount of oil (refer to Gearbox Oil Level on
Page 18 for detailed instructions).
4. Connect the machine to power.
6. verify that the machine is operating correctly
by pushing the stArt button.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
7. press the stop button to stop the machine.
8. WithoUt resetting the switch, press the
stArt button. the machine should not
start.
—if the machine does not start, the stop
button safety feature is working correctly.
the
Test Run is complete.
—if the machine does start (with the stop
button pushed in), immediately disconnect
power to the machine. the stop button
safety feature is not working correctly. this
safety feature must work properly before
proceeding with regular operations. Call
tech support for help.
5. push the stop button in, then twist it clock-
wise so it pops out. When the stop button
pops out, the switch is reset and ready for
operation (see
figure 12).
figure 12. resetting the switch.