Gateway E-826R - Manual (Page 44)

Using cartridges www.gateway.com
39
To insert a cartridge into a magazine slot:
1 From the Main menu, scroll to Commands, then press E NTER . The
Commands submenu opens.
2 Scroll to Enter, then press E NTER . The Enter submenu opens.
3 Scroll to To Location, then press E NTER . The message “Insert Tape, Push
Until Prompted” appears on the LCD.
Important
For the autoloader, push in the cartridge
until it stops. The cartridge should be
about 3 inches (7.5 cm) inside the
mailslot. This may require that you push
and have your fingers well within the
mailslot opening. After insertion, the end
of the cartridge should be visible at the
back of the mailslot opening.
4 Insert the cartridge. After approximately five seconds, the system
automatically verifies that a cartridge is inserted and continues the
process. The message “Tape Loaded” appears when the process is
successfully completed.
5 After you have inserted the cartridge, press E NTER .
If the load cartridge function fails, the cartridge ejects, the message
“Missed Tape” appears, and you must perform
Step 3 and Step 4 again.
6 Scroll through the magazine slots and view their status until you find the
appropriate slot. Slots that are occupied by a data cartridge are indicated
by an asterisk (*). Scroll to the slot where you want to store the cartridge,
then press E
NTER .
Moving a single cartridge
You can move a single cartridge from one location to another inside the
autoloader.
To move a single cartridge:
1 From the Main menu, scroll to Commands, then press E NTER . The
Commands submenu opens.
2 Scroll to Move, then press E NTER . The Move screen appears under From:.
If you select an empty From: location, “No Source Tape” appears on the
LCD. Choose a different location.
3 Scroll to the current location of the cartridge you want to move. Slots that
are occupied by a data cartridge are indicated by an asterisk (*).
4 From To:, scroll to the location to which you want to move the cartridge.
Slots that are occupied by a data cartridge are indicated by an asterisk (*).
Press E
NTER .
If you select a To: location that is already occupied, “Destination Full”
appears on the LCD. Choose a different location.