beautypg.com

Logging out, Using cartridges – Gateway E-826R User Manual

Page 42

background image

Using cartridges

www.gateway.com

37

When you enter a password, all password-protected functionality is available
until you close your browser session. If you do not use the front panel for 10
minutes, the Main screen reappears on the LCD. When the Main screen
reappears, the autoloader has automatically logged you out. You must re-enter
your password again to access the menu functionality.

Logging out

To log out of the autoloader:

1

From the Main menu, scroll to Commands, then press E

NTER

. The

Commands submenu opens.

Tips & Tricks

You can also press E

SCAPE

to log out.

Continue pressing E

SCAPE

until the Main

screen appears.

2

Scroll to Log Out, then press E

NTER

. “Session Complete” appears on the

LCD.

Using cartridges

Tips & Tricks

Whenever you see Enter or Eject on the

front panel menu, it means the tape

enters and leaves the autoloader through

the mailslot. Whenever you see Load or

Unload, it means the tape is loaded into

or unloaded from the tape drive.

Typically, when you first install the autoloader, you load your cartridges into the
magazines, then load the magazines into the autoloader. However, you can
insert and eject cartridges individually using the mailslot, or you can eject a
magazine, manually load and unload cartridges, then load the magazine back
into the autoloader. The autoloader automatically detects the presence of a
cartridge in the magazine slot.

Warning

If a tape cartridge is holding the mailslot
door open on power up, the robot cannot

move. The system detects that the

mailslot door is open but cannot detect

the presence of the tape. If the mailslot

door is open, the bar code scanner laser

light may shine out the door and

potentially cause physical injury.

With the mailslot door open, do not insert
your hand through the mailslot door. This
is to prevent bodily injury from the robot.

Precautions are in place to prevent the

robotic mechanism functioning in this

circumstance.

If you try to perform an illegal operation, the autoloader refuses to perform the
operation. For example, if you try to load a cartridge through the mailslot to the
drive but the drive already contains a cartridge, the mailslot does not unlock.
If you try to unload a cartridge from the drive while the autoloader is writing
to the tape, the command is not initiated until the write command is completed.

This manual is related to the following products: