Setting security options – Gateway E-826R User Manual
Page 64

Using the Configuration page
www.gateway.com
59
3
To change the IP address from a static address to a dynamic address, click
the box next to DHCP.
To set the network configuration:
1
To change the values of the subnet mask, gateway, Simple Network
Management Protocol (SNMP) server, or the time server, type in the new
address, using the T
AB
key to move from box to box.
2
Click Submit.
Setting security options
When you enable the security option, users must enter a password to access
the autoloader's front panel functionality (see
). A password allows either administrator-level access or
operator-level access (see
).
To set security:
1
From any page, click Configuration. The Configuration screen opens.
2
Click Security on the left side of the screen. The System Security section
of the screen displays.
3
To enable front panel security, click the box next to Front Panel Security
Enabled.
If the box is blank, the security option for the front LCD panel is not
enabled.
4
Click Submit.
To reset the front panel password:
1
From any page, click Configuration. The Configuration screen opens.
2
Click Security on the left side of the screen. The System Security section
of the screen displays.
3
Click the box next to Reset Front Panel Password. A check mark appears.
4
Click Submit.
To set User Administration:
1
From any page, click Configuration, then press E
NTER
. The Configuration
submenu opens.
2
Click Security on the left side of the screen. The System Security section
of the screen displays.