GE Industrial Solutions Digital Energy SNMP_WEB ADAPTER - Manual (Page 20)

NOTE: Although the console interface provides a full set of commands, access using the serial
connection is only needed for initial configuration when no DHCP server is available, or the IP-address is
unknown. The quick network configuration menu provides a simple interface for basic network
configuration. For all other settings the user-friendly web interface is recommended.
NOTE: Save the settings !
Apart from some network parameters, most setting are immediately active. However, the adapter will
revert to the last saved settings at reboot. Therefore, in order to permanently modify the SNMP/Web
adapter setting, remember to save the configuration after every change. This can be done:
•
Pressing S on the quick configuration menu
• Entering nvsave at the command interface prompt
4.1.2 Configuration via the network
TELNET
•
Launch a telnet client (e.g. on a PC running Windows, select Run from the Start menu and type
telnet )
• The default username (login) and password are ge and ge
• A command-line configuration interface is entered
WEB BROWSER
•
Launch a web browser
• Enter the URL of the SNMP/Web adapter: http:///
• The default username and password are ge and ge
• Navigate the pages using the menu bar
NOTE: Save the settings !
Apart from some network parameters, most setting are immediately active. However, the adapter will
revert to the last saved settings at reboot. Therefore, in order to permanently modify the SNMP/Web
adapter setting, remember to save the configuration after every change.
Modifications reserved Page 20/24
ISG_CNT_SNM_BAS_CRD_1GB_V012.doc Installation Guide SNMP/Web Adapter