Fluke THE HART 1529 - Manual (Page 98)

8.4.3.2 ROUTe:CLOSe
Enables the specified channel.
ROUT:CLOS 3
The parameter specifies the channel (1 to 4) to enable. This comand
does not apply to memory channels.
8.4.3.3 ROUTe:OPEN?
Returns the state of the specified channel.
Example: ROUT:OPEN? 1
Response: 0
The parameter specifies the channel (1 to 4). If the specified channel is
enabled this query returns 0. If the specified channel is disabled, this query re-
turns 1.
8.4.3.4 ROUTe:OPEN
Disables the specified channel.
Example: ROUT:OPEN 4
The parameter specifies the channel (1 to 4) to disable. This command
does not apply to memory channels.
8.4.3.5 ROUTe:SCAN?
Returns a comma delimited list of the enabled channels.
ROUT:SCAN?
(@2,3,4)
The list of channels is enclosed in parenthesis and preceded with the @
symbol.
8.4.3.6 ROUTe:SCAN
Sets the channels for scanning.
ROUT:SCAN 2,3
The parameter is a comma delimited list of the channels (1 to 4) to
enable. Channels that are omitted from this list are disabled. If the
parameter is omitted, all channels are disabled. The *RST command sets chan-
nel 1 ON, and all other channels OFF.
8.4.3.7 ROUTe:SCAN:MODE? [MIN|MAX|DEF]
Returns the current scan mode setting.
1529 Chub-E4 Thermometer Readout
User’s Guide
92