Calibrate:parameter:offset? [min|max|def – Fluke THE HART 1529 User Manual
Page 104

CAL1:DATE:DUE?
2001,9,21
The CALibrate suffix,
does not apply to memory channels. The response is returned in the format,
2000,1,1. Specifying the MAX parameter returns a value of 2099,12,31. Spec-
ifying the DEF parameter returns a value of 2000,1,1.
8.4.5.5
CALibrate
Sets the recalibration date for the specified channel.
CAL1:DATE:DUE 2001,8,28
The CALibrate suffix,
does not apply to memory channels. The
ters must all be supplied. The
2099). The
MAX or DEF parameter sets the recalibration date to the minimum, maximum,
or default value respectively.
This command is password-protected. To access this command, the password
must be successfully entered using the SYST:PASS:CEN
(see Section 9.4.11, Password Commands).
8.4.5.6
CALibrate
Returns the calibration offset parameter for the specified channel.
CAL1:PAR:OFFS2?
–1.2
The CALibrate suffix,
does not apply to memory channels. For PRT/Thermistor channels, the calibra-
tion offset suffix
Thermistors (2). For Thermocouple channels, the calibration offset suffix
is ignored and may be omitted. Note: For PRT/Thermistor channels, the value
returned by this command is always in ohms.
For PRT/Thermistor channels, specifying the MIN parameter returns a value of
-9 when the offset suffix
parameter returns a value of -9. For PRT/Thermistor channels, specifying the
MAX parameter returns a value of 9 when the offset suffix
and 9000 when the offset suffix
channels, specifying the MAX parameter returns a value of 9. Specifying the
DEF parameter returns a value of 0.
1529 Chub-E4 Thermometer Readout
User’s Guide
98