FUJITSU MHW2120BS - Manual (Page 286)

Index
DEVICE CONFIGURATION
FREEZE LOCK ...................................5-86
conceptual layer, conceptual diagram ..... 5-14
condition, installation ................................ 3-1
DEVICE CONFIGURATION
IDENTIFY ...........................................5-87
configuration
device..............................................2-1, 2-2
DEVICE CONFIGURATION
IDENTIFY data structure............5-88, 5-89
drive system........................................... 2-3
system .................................................... 2-3
DEVICE CONFIGURATION
RESTORE............................................5-86
connection
drive ....................................................... 2-3
DEVICE CONFIGURATION SET.........5-87 connection to SATA interface................... 1-3
device connector ........................................3-9 connection with host system...................... 3-9
device control field ..................................5-28 connector location ..................................... 3-9
device overview .........................................1-1 connector pinout...................................... 5-10
device ready (DRDY) bit.........................5-27 connector specification
device seek complete (DSC) bit...............5-27 host system .......................................... 3-10
device specification ...................................1-4 connector, device....................................... 3-9
device write fault (DF) bit .......................5-27 controller circuit .................................2-3, 4-4
device/head field......................................5-26 current and power dissipation.................... 1-8
device-initiated interface power
management .........................................1-15
current attribute value.............................. 5-62
current fluctuation (Typ.) at +5 V
when power is turned on........................ 1-9 device-nitiated power management
interface................................................1-15 current LBA under test ............................ 5-70
diagnosis ....................................................6-2 current requirements and power
dissipation.............................................. 1-8 diagnostic code ...............................5-24, 5-43
digital PLL circuit....................................4-12
current span under test............................. 5-71
dimension...................................................3-2 cylinder high field ................................... 5-26
DIPM .......................................................1-15 cylinder low field .................................... 5-25
disk......................................................2-2, 4-2
D disk drive outerview ..................................2-2
disk enclosure ............................................2-2
D/A converter (DAC).............................. 4-14
DMA active - device to host....................5-18
data - host to device or device to host
(bidirectional) ...................................... 5-21
DMA buffer offset field...........................5-28
DMA data-in command protocol...........5-175
data area................................................... 4-15
DMA data-out command protocol.........5-176
data assurance in the event of power
failure................................................... 1-11
DMA setup - device to host or host to
device (bidirectional) ...........................5-19
data buffer ................................................. 1-3
DMA transfer count field.........................5-28
data buffer structure................................. 6-13
DOWNLOAD MICROCODE.................5-45
data for caching ....................................... 6-14
DOWNLOAD MICROCODE
operation...............................................5-45
data format of
device attribute value........................... 5-60
drive connection.........................................2-3
guarantee failure threshold value......... 5-60
drive error logging capability ..................5-64
READ LOG EXT log page 10h........ 5-149,
5-150
drive system configuration ........................2-3
driver circuit.............................................4-15
SMART comprehensive error log........ 5-68
driving ready LED ...................................5-11
SMART summary error log................. 5-66
data format version number..................... 5-61
E
data request (DRQ) bit ............................ 5-27
E_status field ...........................................5-28 data transfer mode ................................. 5-122
effect, blower .............................................2-2 data-surface servo format ........................ 4-15
electrical specification ...............................5-7 DE.............................................................. 2-2
enabling and disabling .............................6-21 device attribute value, data format of...... 5-60
environmental protection ...........................1-2 device configuration...........................2-1, 2-2
environmental specification.......................1-9 DEVICE CONFIGURATION ................ 5-85
IN-2 C141-E249