Panasonic Lumix G100 Mirrorless Camera with 12-32mm Lens - Manual (Page 446)

446
15. Connecting to Other Devices
• If [USB Mode] is set to [PictBridge(PTP)] in the [Setup] menu, the camera
will be automatically connected to the printer without the [USB Mode]
selection screen being displayed. (

357 )
• Take care not to turn off the camera while printing is in progress.
• Do not disconnect the USB connection cable while [ ] (Cable disconnect
prohibit icon) is displayed.
• Disconnect the USB connection cable after printing.
• Turn off the camera and disconnect the USB connection cable before
removing the card from the camera. Otherwise, the recorded data may be
damaged.
• To print images with paper size and layout settings not supported by the
camera, set the [Paper Size] and [Page Layout] to [ ] and then select the
desired settings on the printer.
(For details, refer to the operating instructions for your printer.)
• If a yellow [ ] is displayed, the camera is receiving an error message from
the printer. Check that there is no problem with the printer.
• If the number of prints is high, the pictures may be printed in batches. In this
case, the remaining number of prints indicated may differ from the number
set.
• You cannot print RAW images.
• Images recorded with the following functions cannot be printed:
– Video recording, [4K Burst], [Post Focus]