PLANET VIP-191 - Manual (Page 19)

3
Chapter 3
Access Points & SIP Configuration
Access Poing Selection
To connect to the WiFi network, the phone has to connect to an Access Point (AP). To do so, carry out
the following steps:
1. From the Main Screen, press the Left Button (“Menu”) and select “1. AP Connection”, the
following screen should appear:
Figure 8. Main screen of VIP-191
2. Press the OK button (or the Left Key), and a screen showing the available APs and their
corresponding signal strength will appear. (The precise definition of the number that
corresponds to the signal level is called Signal To Noise Ratio, which indicates the noise level
of an AP. The higher the number, the less noise the AP has.) Also, if there is a icon in front
of the signal bar, it indicates that the AP requires a network key.
Figure 9. Wireless information
3. Press the Down Key to highlight the desired Access Point to be connected.
19