Redialing – Brother Fax-700 User Manual
Page 61
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BAS¡C USES
Redialing
If the number that you have dialed is engaged you can redial
it without having to re-enter the number. There are two ways
of doing this, depending on whether you are using manual
or automatic transmission.
Automatic redialing
Automatic redialing can only be used for faxes that were sent
using automatic transmissions - not for telephone calls. You
can turn automatic redialing ON or OFF (see page 4-15).
When using automatic transmission to send a fax, if the desti
nation number is engaged, the machine will automatically
redial the number up to 3 times at 5 minute intervals.
-
Before using automatic redialing, you can send a different
fax message or make a copy of a document using the
"/«
terrupt" feature. (See page 5-43.)
-
To cancel automatic redialing, press the STOP key. (See
page 4-15.)
Manual redialing
If you obtain a busy signal when sending a fax manually or
using the unit as a telephone, carry out the following proce
dure.
1) Replace the handset or press the
HOOK
key.
2) Pick up the handset or press the
HOOK
key.
3) When you hear the dial tone, press the
REDIAL
key. The
machine will redial the number dialed most recently.
4} If you are sending a fax, press the
START
key when you
hear the answering fax tone. If you are making a telephone
call, simply proceed when the called
party answers.
4-27