AltiGen MAXCS 7.5 Softswitch Deployment Guide User Manual
AltiGen Software
Table of contents
Document Outline
- Introduction
- Minimum Requirements
- Before You Begin
- Installation
- Step 1: Install the HMCP Certification Tool
- Step 2: Run the HMCP Certification Tool
- Step 3: Install MAXCS
- Step 4: Add the System Key
- Step 5: Register Licenses
- Step 6: Configure the HMCP Virtual Board
- Step 7: Configure HMCP Codec Preferences for SIP Trunk Calls
- Step 8: Configure the SIPSP Virtual Board
- Step 9: Block Unauthorized SIP Invite Messages
- Step 10: Configure the SIP Trunks
- Step 11: Configure SIP Trunk Groups
- Step 12: Create a SIP Trunk Profile
- Step 13: Configure a Codec Profile
- Step 14: Assign the Codec Profile to the Two SIP Servers
- Step 15: Configure NAT
- Step 16: Add a New SIP Trunk Profile
- Step 17: Channel Configuration
- Step 18: Out Call Routing
- Step 19: Configure Inbound Routing
- Step 20: System Configuration
- Step 21: Configure Polycom Phones
- AltiGen Technical Support