AltiGen MAXCS 7.5 Softswitch Deployment Guide - Manual (Page 26)

Page 26 of 37 MAXCS 7.5 All-Software Solution Deployment Guide
SIP Trunk Profile Field Description
SIP Protocol Field
Not Sent (default) – Do not send transmitted caller ID
FROM Header – Send the caller ID using the SIP FROM header
P-Preferred Identity – Send the caller ID using the SIP
P-Preferred Identity header
P-Asserted Identity – Send the caller ID using the SIP
P-Asserted Identity header
Carrier can accept any number This is the default.
Carrier can only accept Calling
Number with minimum x digits
Enter the number of digits, and then enter a calling number in the
field below the table in case the carrier cannot accept configured
numbers.
Carrier can only accept
assigned numbers as Calling
Number
If you select this option, specify “assigned numbers” by clicking the
Add button and entering the numbers. To edit or delete a number
you added, select it and click the Edit or Del button. Enter a calling
number in the field below the table in case the carrier cannot accept
configured numbers.
Send Caller Name Check to also send the caller name to callees.
Enable Standard Record-
Route Header
Check this box if the SIP service provider uses SIP Record-Route
and the SIP trunk cannot make or receive calls. If it already works,
DO NOT CHECK or UNCHECK this box. [Service provider
Bandwidth.com with Edgewater Route require this checked]
Incoming DID Number Field
When a call comes in, the SIP trunk uses To Header or Request
URI as the DID/DNIS number
Enable Fax Trunk Routing
This feature is supported on AltiGen SIP trunks only.
If the extension is a fax extension and Fax Trunk routing is checked,
that means the SIPSP should use the Fax Username and Fax
password of SIP Trunk profile instead of regular username and
password of SIP Trunk to negotiate with the SIP Trunk.
If the extension is a fax extension but Fax Trunk routing is
unchecked, that means the SIPSP should use the regular username
and password of the SIP Trunk to negotiate with the SIP Trunk side.
Fax User Name – The user name for fax routing
Fax Password – The password for fax routing
Step 13: Configure a Codec Profile
Next, configure a Codec Profile for the SIP trunks in Enterprise Manager:
1. In MAXCS Administrator, select VoIP > Enterprise Network Manager.
2. Click the Codec button on the Quick Launch bar (this is different from the IP Codec tab).