AltiGen MAXCS 7.5 Softswitch Deployment Guide - Manual (Page 30)

Page 30 of 37 MAXCS 7.5 All-Software Solution Deployment Guide
Step 17: Channel Configuration
Note: These steps apply only to deployments using AltiGen SIP Trunks. Before you begin, retrieve the
configuration details from the MaxCS Cloud Services portal, in the SIP Services section of the General
tab of your account.
If your deployment uses SIP services from another AltiGen-certified SIP Trunk carrier, you will need to
get the specific configuration details from that provider. Configuration details will vary from one
provider to another.
For load balancing, you will assign half of the channels to the first server, 65.254.44.194, and the remaining
half to the second server, 74.81.71.18.
In addition, you will configure only the
first channel in each half to register.
1. Determine the number of SIP Trunk channels available, and determine the channel number mid-way
through the list. This channel will be the first of the channels that uses the second server.
For example, if you have 20 channels, consider the 11
th channel as the channel that switches to the
second server. You would assign the first 10 channels to the first server, and the last 10 channels to
the second sever. (See the following figure for an example.)
2. Jot down this mid-point channel number; we’ll refer to this as ChannelB in later steps, to avoid
confusion. You can also note the range of channels for the first and second servers.
ChannelB: ____________
1
st Server channels: ________ - ________
2 nd Server channels: ________ - ________
ChannelB