AltiGen MAXCS 7.5 Softswitch Deployment Guide - Manual (Page 33)

MAXCS 7.5 All-Software Solution Deployment Guide Page 33 of 37
• For Password, paste the same string as for the first set of channels; click Hide/Show Password to
see it.
• For Domain, paste the URL from the second SIP Trunk address in the Cloud portal. This will be
different from the URL for the first set of channels. In our example, this is gw2.sip.us.
• Set the SIP Register Period to 0. (You will modify this again, for just ChannelB, later)
• Set the SIP Trunk Profile to Default.
• Set the SIP Source Port to 5060.
• Set the SIP Destination Port to 5060.
• Select Enable Channel.
3. Copy the configuration of ChannelB to the rest of the last half of the channels:
a. Select ChannelB and click Copy To.
b. Select the range of channels from the next channel (after ChannelB) through all of the rest of the
channels. In our example, you would copy the configuration of channel 10 to channels 11 through
19. Click OK.
4. Now edit ChannelB to specify a registration period other than 0, so that this trunk will send a
registration message to the carrier:
a. Select ChannelB. Click
Edit.
b. Change the SIP Register Period setting to 60. Click OK.
Check Your Configuration
1. In the SIP Trunk Configuration panel, the first half of your channels should list the first server and the
remaining channels should list the second sever.
In addition, the first channel and ChannelB should both show a registration period of 60 seconds; all
other channels should show that field as empty.
In the next figure, ChannelB is channel number 122 (ID 50); channels above it are assigned the first
server, the rest are assigned to the second server, and ChannelB has a Register Period of 60
seconds.
2. If your configuration is not correct, make the necessary adjustments before you continue.