Goulds Pumps CV 3196 i-FRAME - IOM User Manual
Installation, operation, and maintenance manual
Table of contents
Document Outline
- Introduction and Safety
- Transportation and Storage
- Product Description
- Installation
- Preinstallation
- Baseplate-mounting procedures
- Install the pump, driver, and coupling
- Pump-to-driver alignment
- Alignment checks
- Permitted indicator values for alignment checks
- Alignment measurement guidelines
- Attach the dial indicators for alignment
- Pump-to-driver alignment instructions
- Perform angular alignment for a vertical correction
- Perform angular alignment for a horizontal correction
- Perform parallel alignment for a vertical correction
- Perform parallel alignment for a horizontal correction
- Perform complete alignment for a vertical correction
- Perform complete alignment for a horizontal correction
- C-face adapter
- Grout the baseplate
- Piping checklists
- Commissioning, Startup, Operation, and Shutdown
- Preparation for startup
- Remove the coupling guard
- Check the rotation
- Impeller-clearance check
- Impeller-clearance setting
- Couple the pump and driver
- Shaft-sealing options
- Pump priming
- Start the pump
- Activate the i-ALERT™ Condition Monitor
- i-ALERT™ Condition Monitor routine operation
- Pump operation precautions
- Shut down the pump
- Deactivate the i-ALERT™ Condition Monitor
- Reset the i-ALERT™ Condition Monitor
- Make the final alignment of the pump and driver
- Maintenance
- Maintenance schedule
- Bearing maintenance
- Shaft seal maintenance
- Disassembly
- Disassembly precautions
- Tools required
- Drain the pump
- Remove the coupling
- Remove the back pull-out assembly
- Remove the coupling hub
- Impeller removal
- Seal-chamber cover removal
- Remove the seal-chamber cover (3196, CV 3196, HT 3196, LF 3196, 3796)
- Remove the stuffing-box cover (3196, CV 3196, HT 3196, LF 3196, 3796)
- Remove the dynamic seal
- Remove the frame adapter (MTi, LTi , XLT-i)
- Remove the inboard labyrinth oil seal
- Power-end disassembly
- Disassemble the bearing frame
- Guidelines for i-ALERT™ Condition Monitor disposal
- Disassemble the C-face adapter
- Pre-assembly inspections
- Reassembly
- Assemble the rotating element and the bearing frame ( STi and MTi )
- Assemble the rotating element and the bearing frame ( STi and MTi with duplex bearings)
- Assemble the rotating element and the bearing frame ( LTi )
- Assemble the rotating element and the bearing frame ( XLT-i and i17 )
- Assemble the rotating element and the bearing frame ( XLT-i and i17 with duplex bearings)
- Assemble the frame
- INPRO labyrinth oil seal description
- Assemble the INPRO labyrinth oil seal
- Assemble the C-face adapter
- Shaft sealing
- Install the impeller
- Attach the i-ALERT™ Condition Monitor to the pump
- Post-assembly checks
- Install the back pull-out assembly (except HT 3196)
- Assembly references
- Spare parts
- Interchangeability drawings
- Lubrication conversion
- Troubleshooting
- Parts Listings and Cross-Sectional Drawings
- Certification: CE or CE ATEX
- Other Relevant Documentation or Manuals
- Local ITT Contacts