FEC DSP1500 (SAN3) User Manual
Page 9
enFORCE
SAN Unit Operation Manual
PAGE 6 - 9
Chapter 6: System Operation
6.3.3 RUN Status Key Operation
Selecting [Real Time Display Mode], [Press Result Display Mode] and [Parameter Display Mode]
is possible by pressing the [MODE] button. When the press is operating, the [Press Condition
Display] is displayed.
[Status Display] will be displayed when abnormalities occur or when the STOP or Limit signals are
OFF.
The following diagram shows how to change the display with the [MODE] button.
Real Time
Display Mode
Parameter
Display Mode
Press Result
Display Mode
Operating Condition
Display
Power ON
Press Start
Press Finish
[MODE]
[MODE]
[MODE]
D-NO
１
figure
D-NO
2 figure
D-NO
Left side fig
D-NO
in: initial
Fr: Approach
SL: Slow Down
Ld
: Load Speed
Real Time
Display Mode
Press Result
Display Mode
Status
Display
D-NO
１
figure
D-NO
Left side fig
Abnormal or STOP / Limit signal OFF
DATA
Abn/STOP
Parameter
Display Mode
D-NO
2 figure
[MODE]
[MODE]
[MODE]
[MODE]
D-NO
In: Slow Start
Fr: Approach
SL: Part Search
Ld
: Press
ru
: Return
d’
: Load Hold