FEC DSP1500 (SAN3) - Manual (Page 40)

enFORCE SAN Unit Operation Manual
PAGE 6 - 40
Chapter 6: System Operation
¾ Data Number 30 - Advance Position ON Distance (Data number OA set to [1~9]xxx)
¾ Data Number 31 - Advance Position OFF Distance (Data number OA set to [1~9]xxx)
ƒ When Parameter 00, D-No. 0A (Option Setting) is set to a number other than zero, these
settings control the “On” and “Off” of the Timing Signal while the press is advancing.
¾ Data Number 32 - Return Position ON Distance (Data number OA set to [1~9]xxx)
¾ Data Number 33 - Return Position OFF Distance (Data number OA set to [1~9]xxx)
ƒ When Parameter 00, D-No. 0A (Option Setting) is set to a number other than zero, these
settings control the “On” and “Off” of the Timing Signal while the press is returning.
¾ Data Number 33 - Load Rate Change (Method 2-2)
ƒ It sets the load value for detecting load rate increase when the operation method is [Load
Rise Detection].
¾ Data Number 40 - Slow Start Time
¾ Data Number 50 - Slow Start Speed
ƒ Ramp up speed and time value at start of cycle.
Initial speed is performed during initial time.
¾ Data Number 41 - 1 ST Time High Limit (used prior to V2.0)
ƒ Maximum time allowed to reach Interference Check Load (Part Check Load High) or
Interference Check Distance (Part Check Distance) from start of cycle.
Operation will stop if this time is exceeded.
¾ Data Number 42 - 2 ND Time High Limit (used prior to V2.0)
ƒ Maximum time allowed to reach Target Distance or Target Load from Interference Check
Load (Part Check Load High) or Interference Check Distance (Part Check Distance).
Operation will stop if this time is exceeded.
¾ Data Number 42 - Press Time (Method 3)
ƒ The amount of time the press will run after reaching [18: Time Start Load].
30
33
ON
OFF
31 OFF
ON
32
0mm
150mm
Example #1
[30: 50.0mm]
[31: 120.0mm]
[32: 150.0mm]
[33: 100.0mm]
30
33
ON
OFF
150mm
Example #2
[30: 50.0mm]
[31: Max Distance]
[32: Max Distance]
[33: 100.0mm]
0mm