FEC DSP1500 (SAN3) - Manual (Page 33)

enFORCE SAN Unit Operation Manual
PAGE 6 - 33
Chapter 6: System Operation
♦ Distance Control with Load Limit (Method 7)
Upon start of cycle, the press will operate until it achieves [22: Target Distance].
During the press cycle, after achieving [13: Target Load], the press rate will be current
controlled to hold [13: Target Load] until [22: Target Distance] is reached. During the
press cycle, checks are performed for “Interference Check” / “Part Check”, Load and
Distance. If any of these values are compromised, the press will stop and return as
programmed.
(See corresponding sections for Interference Check and Part Check explanations.)
ƒ If “Interference Check” or “Part Check” are not used, set [15: Interference Check
Load / Part Check Load High] and [17: Part Check Load Low] to [10: CAL
Load] and [23: Interference Check Distance / Part Check Distance] to a
minimum of [21: Distance High Limit].
ƒ Review Speed Section explanations and cautions when setting [15: Interference
Check Load / Part Check Load High], [14: Press Speed Start Load], [24: Press
Speed Start Distance] and [20: Approach Distance].
Load
Distance
[12] Load High Limit
[11] Load Low Limit
[13] Target Load
[15] Part Check Load High
(Interference Check Load)
[17] Part Check Load Low
[20]
Distance
Low Limit
[21]
Distance
High Limit
[23]
Part Check Distance
(Interference Check Distance)
Part Check - High
(Interference Zone)
Final Judgment Zone
[22]
Target
Distance
Part Check - Low