FEC DSP1500 (SAN3) - Manual (Page 11)

enFORCE SAN Unit Operation Manual
PAGE 6 - 11
Chapter 6: System Operation
6.3.5 Press Result Display Mode
The following is displayed on the screen in the Press Result Display Mode.
The [D-NO] changes by pressing the [↑] and [↓] buttons.
D-NO DATA UNIT
＿０ Peak Load Value（Judgment Load Value） KN
＿１ Final Distance Value mm
＿２ (Not Used) 1 st Load Rate Value KN/mm
＿３ (Not Used) 2 nd Load Rate Value KN/mm
＿４ 1 st Region Operating Time Sec
＿５ Final Region Operating Time Sec
＿６ Cycle Time Sec
＿７ Operation Mode Number
＿８ Thermal value at Operation End (abnormal occurs if greater than 100)
＿９ Lower 4 digits of final distance value (v1.96 or later)
－０ Press Method Number
－１ Step
－２ Distance when Press Speed Load was Detected (v1.96 or later) mm
－３ Self Check ON: performed OFF: not performed
－４ Speed when Speed Change Load was Detected (v1.96 or later) mm/sec
－５
Cause of press stop
0: Reset／No Data／After manual operation 1: Abnormal
2: BYPASS signal 3: STOP signal 4: REJECT
5: ACCEPT signal 6: START signal OFF * 7: CW signal *
8: CCW signal * *(v1.96 or later)
－６ Load Judgment Ld (Blank=Accept, H=High Reject, L=Low Reject)
－７ Distance Judgment dS (Blank=Accept, H=High Reject, L=Low Reject)
－８ Load Rate Judgment rt (Blank=Acc., H=High Rej., L=Low Rej., Z=1 st Zone)
－９ Time Judgment Γｉ (1 ST , 2 ND
） (Blank=Accept, H=High Reject)
＝０ (Not Used) 1 ST Load Rate Area Increment Load KN
＝１ (Not Used) 2 ND Load Rate Area Increment Load KN
＝２ (Not Used) 1 ST Final Load KN
＝３ (Not Used) 1 ST Peak Load KN
＝４ Final Load Value KN
＝５ Distance at Peak Load (judgment load） mm
「
D-NO」 「DATA」
Peak load value
Final Distance value
1ST Load Rate
Distance at Peak Load
D-NO ： left side figure
０
１
２
５
[↑] / [↓]
buttons