Setting the fax-error-correction mode, To change the error-correction setting – HP 2820 User Manual

Page 130

Setting the fax-error-correction mode

Usually, the device monitors the signals on the telephone line while it is sending or receiving
a fax. If the device detects an error during the transmission and the error-correction setting is
On, the device can request that the portion of the fax be resent. The factory-set default for
error correction is On.

You should turn off error correction only if you are having trouble sending or receiving a fax,
and you are willing to accept the errors in the transmission. Turning off the setting might be
useful when you are trying to send a fax overseas, or receive one from overseas, or if you
are using a satellite telephone connection.

To change the error-correction setting

1. On the device control panel, press

ENU

2. Use the

or the

button to select Fax setup, and then press

NTER

3. Use the

or the

button to select All faxes, and then press

NTER

4. Use the

or the

button to select Error correction, and then press

NTER

5. Use the

or the

button to select On or Off, and then press

NTER

to save your

selection.

114

Chapter 8 Fax

ENWW

This manual is related to the following products:

2840 Color LaserJet 2800 All-in-One Printer series