HP ZT1100 - Manual (Page 36)

2-14 Removal and Replacement HP Pavilion zt1100/xz100 Omnibook xt1000
Reassembly Notes
• Carefully press the SDRAM module into the connector at an angle of about 30°, until it is fully
inserted. Then press down on both sides of the module until the latches snap closed.
Figure 2-11. Installing an Expansion SDRAM Module
Removing the System SDRAM Module
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. Remove the keyboard cover (page 2-9).
3. Open the keyboard (page 2-11, steps 1 though 4). You don’t need to disconnect the keyboard cable.
4. Press outward to release the latches at the sides of the SDRAM module (so that the free edge of the
module pops up), then pull the module out of the connector.
Figure 2-12. Removing the System SDRAM Module
Reassembly Notes
• Carefully press the SDRAM module into the connector at an angle of about 30°, until it is fully
inserted. Then press down on both sides of the module until the latches snap closed.