Removing an sdram module, User-replaceable), Removing an expansion sdram module – HP ZT1100 User Manual
Page 35
HP Pavilion zt1100/xz100 Omnibook xt1000
Removal and Replacement
2-13
Removing an SDRAM Module
(User-Replaceable)
The notebook has no SDRAM built into its motherboard, but has two slots for PC133 SDRAM
modules: a system SDRAM slot beneath the keyboard (containing an SDRAM module installed at the
factory), and an expansion slot on the bottom of the unit.
Caution
Provide proper grounding and handle the SDRAM module only by its edges, or you could damage
the module through electrostatic discharge.
Required Equipment
• #0 Phillips screwdriver.
Removing an Expansion SDRAM Module
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. On the bottom of the notebook, loosen the screw holding the SDRAM cover (the cover retains the
screws), and remove the cover.
3. Press outward to release the latches at the sides of the SDRAM module (so that the free edge of the
module pops up), then pull the module out of the connector.
Figure 2-10. Removing an Expansion SDRAM Module