HP ZT1100 - Manual (Page 29)

HP Pavilion zt1100/xz100 Omnibook xt1000 Removal and Replacement 2-7
Figure 2-5. Removing the Hard Disk Tray
Reassembly Notes
• Insert the connector end of the drive through the opening in the tray, then lower the drive into
place.
• Carefully slide the hard drive assembly into its compartment. Press firmly to make sure the
connector seats properly.
Important
If you are installing a new hard disk drive, install the factory software and operating system on the
drive before loading any additional software—see “Recovering and Reinstalling Software,” below.
Screws,
M2.5x4mm (2)
Screws,
M2.5x4mm (2)