Holder C 9.92 H - Manual (Page 104)

C 9.92 Operating Instructions
102 153 146
Operating the attachments
Turning on the rear PTO
NOTE
The rear PTO can be turned on with the con-
trol lever (3) in the area of the articulated joint.
The control positions are shown on the in-
struction plate (2).
- The safety switch (1) must be switched off.
- Pull the control lever (3) up to turn on the rear PTO.
DANGER
Before turning the PTO on, make sure that
no-one is standing close enough to the trac-
tor and the driven attachment to be hurt.
- Release the lock at the safety switch (1) and depress
the switch. The rear PTO is turned on.
- To turn the PTO off, press the safety switch (1) up.
- Push the control lever (3) down again.
DANGER
After the PTO is turned off, the installed at-
tachment could continue to run. Wait until the
attachment is stationary before working on it
again.
Bild_C992H_093
1
Bild_S 990_008
Ein
Aus
3 2