Turn on the heater – HP 10000s User Manual

Page 26

When you press power on, the printer performs a power-on self-diagnostic test and the following
messages are displayed on the front panel.

(If a 64" paper roll is loaded).

NOTE

Unless there is an emergency, only turn off the printer while PRINTER READY is

displayed on the front panel. Do not turn off the printer while INITIALIZING or PH
RECOVERY is displayed on the front panel to avoid ink drops and damage to the printhead.

When you turn the printer power on, the heater front panel display turns on. Turn on the heater power
on/off switch at the rear of the printer to use the heater.

When the heater power is off, the following message is displayed on the front panel.

Turn on the heater

Press the power switch (1) at the rear of the printer (right hand side viewed from the rear of the printer).

NOTE

Use the heater switch at the rear of the printer only when turning the printer off completely

for removal, installation, or servicing.

Chapter 1 Introduction

ENWW

Int
rod
uct
ion