HP 10000s User Manual
Page 100
b.
Press the
OK
key to confirm.
NOTE
If you wish to select a media type that is currently not available, then you will
need to create a new media type.
c.
If required, select the NEW MEDIA ENTRY option using the or key and press the
OK
key
(Refer to
Manage media types
).
Press the
Cancel
key to return to the SELECT MEDIA menu.
23.
Install the tension bar. For full details of how to prepare the tension bars (Refer to
Tension bars
).
CAUTION
Do not mount the flanges on the tension bar.
a.
Adjust the tension bar (1) length to half the media width.
b.
At the front of the printer, use the black media advance switch to feed enough media so that you
can install the tension bar (1) in the slack area of the media.
NOTE
Make sure the tension bar (1) is positioned in the center (widthwise) of the
slack area of the media or the media may not feed smoothly .
NOTE
If the media does not roll out smoothly, adjust the tension bar (1) length to be
a little shorter than the width of the media.
24.
Install another tension bar (fixing bar) in the tension bar guide at the front of the printer (feed side).
NOTE
Refer to
Tension bars
for full details concerning the adjustment of the tension bar
(fixing bar) length.
a.
Adjust the tension bar (1) length to match the width of the media.
b.
Fit flanges to each end of the tension bar.
90
Chapter 2 How do I perform basic media operations?
ENWW
How
do
I p
erf
or
m b
asic m
edia
o
p
erat
ions?