HP 10000s - Manual (Page 144)

9. Remove the main scroller (1) from the printer on the feed side (Refer to Remove a media roll from the
printer ).
10. Remove the media roll from the main scroller (A), reverse the media roll (from left to right), and reinstall
it on the scroller (B).
11. Install the main scroller in the printer on the feed side and feed the media into the printer (Refer to
Install a media roll in the printer using the main scroller ).
12. Adjust the media so that the mark that you made earlier is aligned with the groove in the platen. If it
does not align with platen groove at both sides, align either end first, and then while holding the aligned
side in place, pull the other side to adjust its position.
134 Chapter 4 How do I perform double-sided printing ENWW
How
do
I per
fo
rm
do
ub
le-si
d
ed
p
rint
in
g