HP 10000s - Manual (Page 152)

13. Insert the top edge of the media (1) into media feeder (2) while stretching it outward to prevent any
wrinkling.
CAUTION Inserting the media obliquely or inserting media with wrinkles could cause a
media jam or skewed feed.
NOTE If the media curls, making it hard to insert into the media feeder, place a backing
sheet on or under the curled media to make loading easier.
14. Adjust the media so that the marks (2) that you made earlier are aligned with the groove (1) in the
platen. If they do not align with platen groove at both sides, align either end first, and then while holding
the aligned side in place, pull the other side to adjust its position.
142 Chapter 4 How do I perform double-sided printing ENWW
How
do
I per
fo
rm
do
ub
le-si
d
ed
p
rint
in
g