HP 6200YL - Manual (Page 256)

IPv6 Access Control Lists (ACLs)
Displaying ACL Configuration Data
Displaying the Content of a Specific ACL
This command displays a specific IPv6 or IPv4 ACL configured in the running
config file in an easy-to-read tabular format.
N o t e This information also appears in the show running display. If you execute write
memory after configuring an ACL, it also appears in the show config display.
For information on IPv4 ACL operation, refer to the latest version of the Access
Security Guide
for your switch.
Syntax: show access-list < identifier > [config]
Display detailed information on the content of a specific ACL
configured in the running-config file.
For example, suppose you configured the following two ACLs in the switch:
Identifier Type Desired Action
Accounting IPv6 • Permit Telnet traffic from these two IPv6 addresses:
– 2001:db8:0:1af::10: 14
– 2001:db8:0:1af::10: 24
• Deny Telnet traffic from all other devices in the same subnet.
• Permit all other IPv6 traffic from the subnet.
• Deny and log any IPv6 traffic from any other source.
List-120 IPv4 • Permit any TCP traffic from 10.30.133.27 to any destination.
Extended • Deny any other IP traffic from 10.30.133.(1-255).
• Permit all other IP traffic from any source to any destination.
Use show access-list < identifier > to inspect a specific IPv6 or IPv4 ACL, as
follows:
8-80