HP 6200YL - Manual (Page 246)

IPv6 Access Control Lists (ACLs)
Editing an Existing ACL
Syntax: remark < remark-str >
< 1-2147483647 > remark < remark-str >
no < seq-# > remark
These commands are used in the ACL context to enter a
comment related to an adjacent ACE. To associate a remark
with a specific ACE, do one of the following:
• Enter the remark first (without a sequence number)
and immediately follow it with the ACE (also without
a sequence number). The remark and the following
ACE will have the same (automatically generated)
sequence number.
• Enter the ACE with or without a sequence number, then
use
<1-2147483647> remark < remark-str > to enter the
remark, where a number in the range of <1-2147483647>
matches the sequence number of the related ACE. This
method is useful when you want to enter a remark at
some time after you have entered the related ACE.
< remark-str >: The text of the remark. If spaces are included in
the remark, then the remark string must be delimited by either
single quotes or double quotes. For example:
remark Permits_Telnet_from_2001:db8:0:1ab_subnet
remark “Permits Telnet from 2001:db8:0:1ab subnet”
remark ‘Permits Telnet from 2001:db8:0:1ab subnet’
<1-2147483647>: The range of valid sequence numbers for an
ACL.
For example, if the sequence number of the last ACE entered is
“30” and sequence numbering is set to the (default) interval of
10, then entering a remark and another ACE without specify­
ing any sequence numbers results in a sequence number of “40”
for both the remark and the ACE that follows it.
The no form of the command deletes the indicated remark, but
does not affect the related ACE.
8-70