HP 6200YL - Manual (Page 254)

IPv6 Access Control Lists (ACLs)
Displaying ACL Configuration Data
Display the IPv4 and IPv6 VACL Assignments for a
VLAN
This command lists the identifiers and type(s) of VACLs currently assigned
to a particular VLAN in the running-config file. For IPv6 ACLs, the switch
supports one VACL assignment per VLAN. For IPv4 ACLs, the switch supports
one inbound and one outbound RACL assignment per VLAN, and one VACL
assignment per VLAN.
Syntax: show access-list vlan < vid >
Lists the current IPv4 and IPv6 ACL assignments to the spec­
ified VLAN (in the running config file).
N o t e This information also appears in the show running output. If you execute write
memory after configuring an ACL, it also appears in the show config output.
For example, the following output shows that all inbound IPv6 traffic and the
inbound and outbound, routed IPv4 traffic are all filtered on VLAN 20.
ProCurve(config)# show access-list vlan 20
Access Lists for VLAN 20
• An extended IPv4 ACL named “Account-2” is
assigned to filter routed IPv4 traffic entering the
switch on VLAN 20.
Inbound Access List: Account-2
Type: Extended • An extended IPv4 ACL named “101” is assigned
to filter routed IPv4 traffic leaving the switch on
VLAN 20.
Outbound Access List: 101
Type: Extended
• An IPv6 ACL named “Blue-Group” is assigned to
filter IPv6 traffic entering the switch on VLAN 20.
Ipv6 VACL Access List: Blue-Group
• There is no ACL configured to filter all IPv4 traffic
entering the switch on VLAN 20.
VACL Access List: None
• There is no IPv4 Connection Rate Filter ACL
Connection Rate Filter Access List: None
assigned to VLAN 10. Refer to the chapter titled
“Virus Throttling (Connection-Rate Filtering)” in
the latest Access Security Guide for your switch.
Figure 8-28. Example of Listing the ACL Assignments for a VLAN
8-78