HP 6200YL User Manual
Page 130
IPv6 Management Features
SNMP Management for IPv6
N o t e
IPv6 is not supported in the configuration of an interface IPv6 address as the
default source IP address used in the IP headers of SNMP notifications (traps
and informs) or responses sent to SNMP requests. Only IPv4 addresses are
supported in the following configuration commands:
snmp-server trap-source < ipv4-addr | loopback < 0-7 >>
snmp-server response-source [dst-ip-of-request | ipv4-addr | loopback < 0-7 >]
IPv6 addresses are supported in SNMP
show command output as shown in
Figure 5-8 and Figure 5-9.
The
show snmp-server command displays the current SNMP policy
configuration, including SNMP communities, network security notifications,
link-change traps, trap receivers (including the IPv4 or IPv6 address) that can
receive SNMPv1 and SNMPv2c traps, and the source IP (interface) address
used in IP headers when sending SNMP notifications (traps and informs) or
responses to SNMP requests.
5-26