HP 6200YL User Manual
Page 95
IPv6 Addressing Configuration
View the Current IPv6 Addressing Configuration
■
DAD Attempts: Indicates the number of neighbor solicita
tions the switch transmits per-address for duplicate
(IPv6) address detection. Implemented when a new
address is configured or when an interface with config
ured addresses comes up (such as after a reboot). The
default setting is 3, and the range is 0 - 600. A setting of
“0” disables duplicate address detection. (Refer to “Dupli
cate Address Detection (DAD)” on page 4-17.)
■
VLAN Name: Lists the name of a VLAN statically configured
on the switch.
■
IPv6 Status: For the indicated VLAN, indicates whether
IPv6 is disabled (the default) or enabled. (Refer to “Config
uring IPv6 Addressing” on page 4-5.)
■
IPv6 Address/Prefix Length: Lists each IPv6 address and
prefix length configured on the indicated VLAN.
■
Expiry: Lists the lifetime status of each IPv6 address listed
for a VLAN:
•
Permanent: The address will not time out and need
renewal or replacement.
•
date/time: The date and time that the address expires.
Expiration date and time is specified in the router
advertisement used to create the prefix for automati
cally configured, global unicast addresses. The
Address
Status field in the show ipv6 command output indicates
whether this date/time is for the “preferred” or “valid”
lifetime assigned to the corresponding address. (Refer
to “Preferred and Valid Address Lifetimes” on page 3
24.)
4-25