HP 6200YL - Manual (Page 94)

IPv6 Addressing Configuration
View the Current IPv6 Addressing Configuration
Syntax: show ipv6 nd
Displays the current IPv6 neighbor discovery settings on the
configured VLAN interfaces.
For example, figure 4-24 shows the output on a switch having IPv6 enabled
on VLANs 1 and 20.
ProCurve# show ipv6 nd
IPV6 Neighbor Discovery Configuration
Current Hop Limit : 0
VLAN Name RCHtime NSint
(msecs) (msecs)
------------ -------- ------- -
DEFAULT_VLAN 30000 1000
VLAN20 30000 1000
Figure 4-2. Example of Show IPv6 nd Output with Default settings
Syntax: show ipv6 vlan < vid >
Displays IP and IPv6 global configuration settings, the IPv6
status for the specified VLAN, the IPv6 addresses (with prefix
lengths) configured on the specified VLAN, and the expiration
data (Expiry) for each address.:
■ IPv6 Routing: For software releases K.13.01 through
K.14.01, this setting is always
Disabled. (Refer to “Router
Access and Default Router Selection” on page 4-28.) .
■ Default Gateway: Lists the IPv4 default gateway, if any,
configured on the switch. This is a globally configured
router gateway address, and is not configured per-VLAN.
■ ND DAD: Shows whether Neighbor Discovery (ND) is
enabled. The default setting is Enabled. Using
ipv6 nd dad-
attempts 0 disables neighbor discovery.
4-24