HP 6200YL - Manual (Page 255)

IPv6 Access Control Lists (ACLs)
Displaying ACL Configuration Data
Display Static Port (and Trunk) ACL Assignments
This command lists the identification and type(s) of current static port ACL
assignments to individual switch ports and trunks, as configured in the
running-config file. (The switch allows one static port ACL assignment per
port.)
Syntax: show access-list ports < all | port-list >
Lists the current static port ACL assignments for ports and
trunks in the running config file.
N o t e This information also appears in the show running output. If you execute write
memory after configuring an ACL, it also appears in the show config output.
For example, the following output shows IPv4 and IPv6 ACLs configured on
various ports and trunks on the switch:
ProCurve(config)# show access-list ports all
Access Lists for Port B1
Inbound Ipv6: List-01-Inbound
Access Lists for Port B12
Inbound : 101
Type : Extended
Inbound Ipv6: Accounting
Access Lists for Port Trk2
Inbound Ipv6: Accounting
Access Lists for Port Trk5
Inbound : Marketing
Type : Extended
• An IPv6 ACL is filtering
inbound traffic on port B1.
• Both an IPv4 ACL and an IPv6
ACL are filtering inbound IPv4
and IPv6 traffic, respectively,
on port B12.
• An IPv6 ACL is filtering
inbound IPv6 traffic on Trunk 2
(Trk2).
• An IPv4 ACL is filtering
inbound IPv4 traffic on Trunk 5
(Trk5).
Figure 8-29. Example of Listing the ACL Assignments for Ports and Trunks
8-79