HP 2700 - Manual (Page 80)

Using Macintosh Configure Device
Macintosh Configure Device is a Web-based program that you can use to configure and maintain the
printer from a computer running Mac OS X V10.3 or V10.4. You can use Macintosh Configure Device
when the printer is directly connected to the computer or when it is connected to the network. You do
not need Internet access in order to open and use Macintosh Configure Device.
NOTE You must perform a complete software installation to use Macintosh Configure Device.
Use Macintosh Configure Device for the following tasks:
● Check the printer status and print information pages.
● Check and change printer system settings.
● Check default print settings.
● Check and change network settings, including the following settings:
IP configuration
Advanced network settings
mDNS settings
SNMP settings
password
To view Macintosh Configure Device when the printer is directly connected to the computer
1. Open HP Director by clicking the HP Director icon in the dock.
2. In HP Director, click Settings.
3. Select Configure device. The Macintosh Configure Device home page opens.
To view Macintosh Configure Device when the printer is connected to a network
1. Open one of the following supported Web browsers:
● Safari 1.2 or later
● Netscape Navigator 7 or later
● Opera 7 or later
2. Type the IP address of the printer into the Web browser address bar. The Macintosh Configure
Device home page opens.
70 Chapter 5 Managing the printer ENWW