HP 2700 - Manual (Page 129)

The printer driver does not automatically set up your selected printer in the Print Center or Printer Setup Utility.
Cause Solution
you are using. Reinstall the software. See the getting started guide
for instructions.
The interface cable might be defective or of poor quality. Replace the interface cable with a high-quality cable.
A print job was not sent to the printer that you wanted.
Cause Solution
The print queue might be stopped. Restart the print queue. Open print monitor and select Start Jobs.
The wrong printer name, IP address, or Rendezvous host name is
being used. Print a configuration page. Verify that the printer name, IP address,
or Rendezvous host name on the configuration page matches the
printer name, IP address, or Rendezvous host name in the Print
Center or Printer Setup Utility.
An EPS file prints with incorrect fonts.
Cause Solution
This problem occurs with some programs. ● Try downloading the fonts that are contained in the EPS file to
the printer before printing.
● Send the file in ASCII format instead of binary encoding.
You are unable to print from a third-party USB card.
Cause Solution
This error occurs when the software for USB printers is not
installed. When adding a third-party USB card, you might need the Apple USB
Adapter Card Support software. The most current version of this
software is available from the Apple Web site.
When connected with a USB cable, the printer does not appear in the Print Center or Printer Setup Utility after the driver is selected.
Cause Solution
This problem is caused by either a software or a hardware
component. Software troubleshooting
● Check that your Macintosh supports USB and has the
appropriate USB software from Apple.
● Verify that your Macintosh operating system is Mac OS X V10.1
or later.
Hardware troubleshooting
● Check that the printer is turned on.
● Verify that the USB cable is connected correctly.
● Check that you are using the appropriate high-speed USB cable.
ENWW Macintosh problems 119