HP 2700 - Manual (Page 32)

System Setup menu
Use this menu to establish basic printer settings. The System Setup menu has several sub-menus.
Each is described in the following table.
Menu item Sub-menu item Sub-menu item Description
Language Select the language for the control-panel
display messages and the printer
reports.
Paper setup Def. paper size Letter
A4
Legal
Select the size for printing internal
reports or any print job that does not
specify a size.
Def. paper type A list of available media
types appears. Select the media type for printing internal
reports or any print job that does not
specify a type.
Tray 1 Paper size
Paper type
Select the default size and type for tray 1
from the list of available sizes and types.
Tray 2 Paper size
Paper type
Select the default size and type for tray 2
from the list of available sizes and types.
Paper out action Wait forever
Override
Cancel
Select how the printer should react when
a print job requires a size or type that is
not available or when a specified tray is
empty.
Select Wait forever to make the printer
wait until you load the correct media and
press
OK . This is the default setting.
Select Override to print on a different
size or type after a specified delay.
Select Cancel to automatically cancel
the print job after a specified delay.
If you select either Override or Cancel,
the control panel prompts you to specify
the number of seconds to delay. Press
> to increase the time, up to
3600 seconds. Press < to decrease the
time.
Print quality Calibrate color After power on
Calibrate now
After power on: Select how soon the
printer should calibrate after you turn it
on. The default setting is 15 minutes.
Calibrate now: Makes the printer
perform a calibration immediately. If a job
is processing, the printer calibrates after
the job is complete. If an error message
is on the display, you must clear the error
first.
Color supply out Stop
Continue black
Select Stop to halt printing until the
empty cartridge is replaced.
22 Chapter 2 Control panel ENWW