HP 3550 - Manual (Page 70)

Setting the idle timeout
1. Press M
ENU
to enter the MENUS.
2. Press to highlight Configure Device.
3. Press to select Configure Device.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO 1.
7. Press to select EIO 1.
8. Press to highlight TCP/IP.
9. Press to select TCP/IP.
10. Press to select CONFIG METHOD.
11. Press to highlight MANUAL.
12. Press to select MANUAL.
13. Press to highlight MANUAL SETTINGS.
14. Press to select MANUAL SETTINGS.
15. Press to highlight IDLE TIMEOUT.
16. Press to select IDLE TIMEOUT.
17. Press the or arrow to increase or to decrease the number of seconds for the idle
timeout.
18. Press to save the idle timeout.
19. Press M
ENU
to return to the Ready state.
Setting the link speed
By factory default, the link speed is set to AUTO. Use the following procedure to set a
specific speed:
1. Press M
ENU
to enter the MENUS.
2. Press to highlight Configure Device.
3. Press to select Configure Device.
4. Press to highlight I/O SUBMENU.
5. Press to select I/O SUBMENU.
6. Press to highlight EIO 1.
7. Press to select EIO 1.
8. Press to highlight LINK SPEED.
9. Press to select LINK SPEED.
10. Press to highlight the desired link speed.
11. Press to select the desired link speed.
12. Press M
ENU
to return to the Ready state.
58 Chapter 3 I/O configuration ENWW