HP 3550 - Manual (Page 67)

Setting the subnet mask
1. Press M
ENU
to enter the MENUS.
2. Press to highlight Configure Device.
3. Press to select Configure Device.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO 1.
7. Press to select EIO 1.
8. Press to highlight TCP/IP.
9. Press to select TCP/IP.
10. Press to select CONFIG METHOD.
11. Press to highlight MANUAL.
12. Press to select MANUAL.
13. Press to highlight MANUAL SETTINGS.
14. Press to select MANUAL SETTINGS.
15. Press to highlight SUBNET MASK.
16. Press to select SUBNET MASK.
NOTE The first of four sets of numbers is highlighted. Each set of numbers represents one byte of
information and has a range from 0 to 255.
17. Press the or arrow to increase or decrease the number for the first byte of the
subnet mask.
18. Press to move to the next set of numbers. (Press to move to the previous set of
numbers.)
19. Repeat steps 17 and 18 until the correct subnet mask is entered.
20. Press to save the subnet mask.
21. Press M
ENU
to return to the Ready state.
ENWW Network configuration 55