HP 3550 User Manual
Page 160
Control panel message
Description
Recommended action
RAM DISK FILE
SYSTEM IS FULL
alternates with
Ready
To clear press
For the HP Color LaserJet 3700 series
printer only.
The printer received a PJL file system
command that attempted to store
something on the file system but was
unsuccessful because the file system is
full.
1.
Use HP Web Jetadmin software to
delete files from the RAM disk
memory and try again.
2.
To remove this message from the
display, press .
for more
information.
RAM DISK IS
WRITE PROTECTED
alternates with
Ready
To clear press
For the HP Color LaserJet 3700 series
printer only.
The file system is protected and no new
files can be written to it.
1.
To enable writing to the RAM disk
memory, turn off write protection
using HP Web Jetadmin.
2.
To remove this message from the
display, press .
for more
information.
RAM DISK X
Initializing
alternates with
DO NOT POWER OFF
The new RAM disk installed in slot X is
initializing.
For the HP Color LaserJet 3700 series
printer only.
No action necessary.
Ready
The printer is online and ready for data.
No status or device attendance
messages are pending at the display.
No action necessary.
Ready
Diagnostics mode
alternates with
To exit press
Cancel Job key
The printer is online and ready for data.
No status or device attendance
messages are pending at the display.
No action necessary.
Receiving
upgrade
A firmware upgrade is in progress.
Do not turn the printer off until the printer
returns to Ready.
RELOAD TRAY X
TRNSPRNCY
alternates with
Verify transparency
meets specification
The transparency currently loaded might
not be supported.
CAUTION
Use only transparencies specified for
use with HP Color LaserJetprinters. Non-
compatible transparencies can damage
the printer. See the HP LaserJet Printer
Family Print Media Specification Guide.
1.
Remove all non-compatible
transparencies from Tray X.
2.
Load compatible transparencies in
Tray 1.
for more
information.
Control panel messages (continued)
148
Chapter 8 Problemsolving
ENWW