HP 3550 - Manual (Page 56)

To set the auto continue
1. Press M
ENU
to enter the MENUS.
2. Press to highlight Configure Device.
3. Press to select Configure Device.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight AUTO CONTINUE.
7. Press to select AUTO CONTINUE.
8. Press or to select the appropriate setting.
9. Press to set the selection.
10. Press M
ENU
.
Supplies low
The printer allows two options for reporting that supplies are low; CONTINUE is the default
value.
● CONTINUE allows the printer to continue printing while displaying a warning until the
supply is replaced or a supply out condition is reached.
● STOP causes the printer to pause printing until you replace the used supply or press ,
which allows the printer to print while continuing to display the warning.
To set supplies low reporting
1. Press M
ENU
to enter the MENUS.
2. Press to highlight Configure Device.
3. Press to select Configure Device.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight SUPPLIES LOW.
7. Press to select SUPPLIES LOW.
8. Press or to select the appropriate setting.
9. Press to set the selection.
10. Press M
ENU
.
44 Chapter 2 Control panel ENWW