HP 16V - Manual (Page 107)

Periodic Routine Maintenance
Installing the New Print Unit
Notice:
To avoid exposing the photoconductor drum to light or
contamination, follow these guidelines:
l
Do not remove the print unit from its envelope until you are ready
to install it.
l
Complete the procedure as quickly as possible to avoid exposing
the drum to light for more than three minutes.
To avoid damaging the drum:
l
Be sure to remove the plastic sheets after installing the print unit.
Operating the printer without removing the sheets will make the
print unit unusable.
l
Never touch or scratch the green drum surface.
Print unit
Green d
l
Be careful not to allow dust or foreign matters into the toner
hopper.
To install the new print unit, follow these steps:
1.
2.
Remove the print unit
from its envelope. Place the
unit on a level, steady place.
Remove the protective
materials from the print
unit. Remove protective
sheet 1 Pull narrow clear
tape 2 until its blue end is
visible and remove it.
4-12 User’s Manual