Hitachi CP-X268AWF - Manual (Page 41)

32
IMAGE Menu
IMAGE Menu
Item Description
ASPECT
8VLQJWKHEXWWRQVŸźVZLWFKHVWKHPRGHIRUDVSHFWUDWLR
For an RGB and MIU signal
NORMAL Щ 4:3 Щ 16:9 Щ SMALL
For a video signal, s-video signal or component video signal
4:3 Щ 16:9 Щ 14:9 Щ SMALL
For a no signal
¿[HG
• The NORMAL mode keeps the original aspect ratio of the signal.
OVER SCAN
8VLQJWKHEXWWRQVŸźDGMXVWVWKHRYHUVFDQUDWLR
Large (It reduces picture) Ù6PDOO,WPDJQL¿HVSLFWXUH
• This item can be selected only for a video, s-video and component signal.
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In such a case, please adjust small.
V POSITION
8VLQJWKHEXWWRQVŸźDGMXVWVWKHYHUWLFDOSRVLWLRQ
Up Ù Down
• Over-adjusting the vertical position may cause noise to appear
on the screen. If this occurs please reset the vertical position to the
default setting. Pressing the RESET button when V POSITION is
selected will reset the V POSITION to the default setting.
For a video signal, s-video signal or component video signal
The adjustable range of V.POSITION depends on the OVERSCAN setting.
It is not possible to adjust when the OVERSCAN is set to 10.
H POSITION
8VLQJWKHEXWWRQVŸźDGMXVWVWKHKRUL]RQWDOSRVLWLRQ
Left Ù Right
• Over-adjusting the horizontal position may cause noise to appear
on the screen. If this occurs please reset the horizontal position to
the default setting. Pressing the RESET button when H POSITION
is selected will reset the H POSITION to the default setting.
For a video signal, s-video signal or component video signal
The adjustable range of H.POSITION depends on the OVERSCAN setting.
It is not possible to adjust when the OVERSCAN is set to 10.
H PHASE
8VLQJWKHEXWWRQVŸźDGMXVWVWKHKRUL]RQWDOSKDVHWRHOLPLQDWHÀLFNHU
Right Ù Left
• This item can be selected only for an RGB signal or a component
video signal.
With the IMAGE menu, items shown in the table below can
be performed.
6HOHFWDQLWHPXVLQJWKHFXUVRUEXWWRQVŸźRQWKH
SURMHFWRURUUHPRWHFRQWURODQGSUHVVWKHFXUVRUEXWWRQŹ
on the projector or remote control, or the ENTER button
on the remote control to execute the item. Then perform it
referring to the following table. /'07=4)$?
+/#)'
2+%674'
5'.'%6
#761#&,756':'%76'
#52'%6
18'45%#0
*2*#5'
*5+<'
*215+6+10
8215+6+10
5'672
+0276
126+10
/+7
'#5;/'07
5%4''0