Resetting to factory defaults – HP 3100C User Manual
Page 38
Administrator tools
37
To shut down
1
Make sure the digital sender is idle.
2
At the control panel, press
S
ETUP
(
A
LT
+
F4
). Then press
S
ETTINGS
(
F2
)
.
3
Select any of the configuration menus. If an administrator
password is required, the HP Digital Sender 8100C
Administrator’s Password dialog box appears. Type the
password and press
O
K
(
F1
).
4
When the configuration menu appears, press
T
OOLS
(
F2
).
5
Select Shutdown and press
O
K
(
F1
).
Note
A shutdown key sequence exists that will shut down the digital sender
if it becomes unresponsive and therefore will not navigate to the
Shutdown option. The code is:
S
HIFT
+
A
LT
+
.
Resetting to factory defaults
Use this procedure for the following reasons:
●
when you want to completely reconfigure the digital sender and
all address books
●
when instructed to do so by troubleshooting steps or
HP customer support
Resetting the digital sender to factory defaults is a combination of
resetting address books and resetting network parameters. It does
the following:
●
erases the administrator password
●
locks the digital sender from use until the reset is complete
●
erases the configuration for TCP/IP, DNS/WINS, security, e-mail,
fax, and LDAP settings
●
erases the contents of all public and personal address books,
distribution lists, and phone books.
Notes about the procedure:
●
After you reset the digital sender to the factory defaults, neither
you nor any users can use the digital sender again until you have
reconfigured it, starting with the steps under
.
CAUTION
This action cannot be undone.